Procedures

INTAKE MANIFOLD RUNNER CONTROL SOLENOID REPLACEMENT

REMOVAL PROCEDURE




1. Remove the upper intake manifold with the lower intake manifold.

IMPORTANT: DO NOT separate the upper intake manifold from the lower intake manifold.

2. Remove the intake manifold runner control solenoid bolts.
3. Remove the intake manifold runner control solenoid.

INSTALLATION PROCEDURE




1. Install the intake manifold runner control solenoid.
2. Install the intake manifold runner control solenoid bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the intake manifold runner control solenoid bolts to 10 Nm (89 lb in).

3. Install the upper intake manifold.