April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

Courtesy of GENERAL MOTORS COMPANY

NOTE:
Be careful to avoid boot damage during installation, boot damage can cause weakened ignition system strength.

Install the boot (2) to the ignition coil (1). The new boot is fully seated when it is within 1 mm (0.040 in) of metal shield.
Courtesy of GENERAL MOTORS COMPANY

Install the EN-6009 remover/installer (1).
Install the ignition coil (2).
Remove the EN-6009 remover/installer (1).
Install the ignition coil fasteners and tighten to 8 N.m (71 lb in).

NOTE:

Note the arrow on the cover.

Install the ignition coil cover in the opposite direction of the arrow.
Courtesy of GENERAL MOTORS COMPANY

Connect the ignition coil electrical connector (2).
Install the engine wiring harness guide (1) at the cylinder head.