Section 19 (Battery System): Battery: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: A SUITABLE PAIR OF HEAVY DUTY RUBBER GLOVES AND SAFETY GLASSES SHOULD BE WORN WHEN REMOVING OR SERVICING A BATTERY.

WARNING: REMOVE METALLIC JEWELRY TO AVOID INJURY BY ACCIDENTAL ARCING OF BATTERY CURRENT.

Make sure ignition switch is in OFF position and all accessories are turned OFF.
Remove the rear compartment floor, trim panel to gain access to the battery.

Fig 1: Disconnecting/Connecting Battery Cables
Courtesy of DAIMLERCHRYSLER CORP.
Disconnect the battery negative cable (2) from the battery terminal.
Disconnect the battery positive cable (1) from the battery terminal.
Unlatch the battery retention strap (4).

Fig 2: Battery Vent Tube
Courtesy of DAIMLERCHRYSLER CORP.

CAUTION: Use care when disconnecting the battery vent tube from the battery. The vent tube nipple is made of plastic and is easily damaged if not disconnected properly.
Gently disconnect the battery vent tube from the battery nipple.

Fig 3: Battery Hold Down Clamp
Courtesy of DAIMLERCHRYSLER CORP.
Remove the battery hold down clamp and remove the battery from the vehicle.