Ignition Distributors - LOADOMATIC: Overhaul: Reassembly

Reverse disassembly procedure and note the following: Shaft and gear are serviced as an assembly only. Press gear on shaft to obtain specified clearance. If a new shaft is installed, drill a 1/8" pin hole through shaft using pin hole in gear should as a guide. With gear installed, measure distance from bottom of mounting flange to bottom of gear.

Distributor Shaft Endplay

Application	Endplay
170", 200", 352", 360", 390"	.022-.033"
240", 300"	.003-.010"

⁽¹⁾Gear Distance

Application

Distance

170", 200", 240"

2.510-2.515"

352", 360", 390"

3.071-3.078"

⁽¹⁾	Distance from bottom of mounting flange to bottom of gear.