Placing System In Operation

After component replacement and/or system servicing has been completed and all connections have been made, proceed as follows:

1. Evacuate the system using a vacuum pump.
2. Charge the system with new R-12 according to each individual vehicle manufacturer's procedure as outlined in this Manual. Also see  REFRIGERANT CAPACITY   in this Section  .
3. Leak test the system, with particular attention to all new connections and components.
4. Make a performance test of the system.
   NOTE: Each of the above procedures is detailed in the GENERAL SERVICE Section of this Manual Also-refer to individual articles within this Supplement for further description of each vehicle's system.