Steering Column Shift Cane Assembly: Disassembly
- Disconnect negative battery cable and remove steering column. Remove 2 bolts attaching shift cane support bracket-to-steering column collar.
- Remove "C" clip retainer at upper end of shift cane assembly. Pull assembly down, and out of bearing and washer located in lock cylinder housing and detent plate. Inspect bearing and replace if damaged or worn.
- Pull plastic trim cover from upper shaft and allow it to hang on selector lever. Remove roll pin connecting selector lever to shift cane upper shaft. Remove selector lever spring and plunger assembly. Replace if worn or damaged.
- Remove selector lever. Slide shift cane lower support bracket off lower shaft. Replace bushing if worn or damaged. Remove metal spacer clip from shift cane stop.
- Measure and record the entire length of shift cane. Mark one side of both upper and lower shafts so they can be reassembled in proper position. Separate shafts.