Steering Column Shift Cane Assembly: Reassembly
- Install lower shift cane support bracket with bushing on lower shaft. Install 2 new anti-rattle clips in grooves on upper shift cane shaft, with both clips installed in same direction. Lubricate lower 6" of shaft with chassis lubricant.
- Place lower shaft in vise and install upper shaft on lower shaft. Ensure length is same as that recorded during disassembly, and that marks line up on same side.
- Install selector lever opening cover loosely on shift lever. Insert selector lever through slot in upper shaft and install new roll pin. Install selector lever opening cover on upper shaft.
- Insert upper end of shift cane into bearing and washer in lock cylinder housing. Install "C" clip retainer. Make sure selector lever mates correctly with detent plate on lock cylinder housing.
- Align lower support bracket with bolt holes on steering column collar and tighten nuts. Check shift cane for smooth rotational action. Lubricate selector lever, plunger, spring and detent plate with chassis lubricant.
- Install steering column assembly. Check shift cane spacer clip gap and replace clip if required.