EGR Reminder Light Reset Procedure
- Turn ignition off. Insert Phillips screwdriver into hole in timer unit. While lightly pushing screwdriver in, turn ignition switch to the "RUN" position.
- With EGR reminder light on, hold screwdriver in place for 5 seconds. Remove screwdriver. Reminder light should go out in 2-5 seconds. If not, repeat steps 1) and 2).
- Turn ignition off. Turn ignition switch to the "RUN" position. Reminder light should come on for 2-5 seconds and then go out. This checks proper reset of light module.
NOTE:
Reminder light is activated by an electronic module which senses engine-on time rather than actual mileage. Reminder light is designed to come on at approximately 60,000 miles.