Controller Function Test

Turn ignition off. Check controller function by connecting a 12-volt test light to test terminal on controller. Position test light so it can be viewed from driver's position. Turn ignition on. Note system operation and compare test light times to TEST LIGHT TIMES table. If test light times are within specification, system function is correct. If test light times are out of specification, disconnect power at both batteries and replace controller unit. Repeat this step.

TEST LIGHT TIMES

Controller ⁽¹⁾ Temp. (°F)

⁽²⁾ "Wait To Start" "ON" Time: Seconds

⁽³⁾ Test Lamp Total Time: Seconds

-20

7-15

35-70

7-12

25-60

5-12

15-35

3-5

7-15

105

1-3

3-5

140

1 or Less

1-3

⁽¹⁾	Temperature of controller unit, NOT ambient temperature.

⁽²⁾	"Wait To Start" light and/or Test light may not glow if engine is at or near normal operating temperature.

⁽³⁾	Total Test light "ON" time includes time from beginning of initial "ON" cycle to end of last "ON-OFF" cycle.