LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1987 >> Tempo Base, 2D Sedan >> Repair and Diagnosis >> Engine Performance >> System >> 2.3L HSC/CFI Testing >> Quick Test >> Key On/Engine Running (KOER) Self-Test >> Code Output
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Code Output

  1. Deactivate SELF-TEST (disconnect jumper wire). Start engine and run it at 2000 RPM for 2 minutes to warm up HEGO sensor. Turn engine off and wait 10 seconds
  2. Start engine. Insert jumper to activate SELF-TEST. The engine ID code will be displayed. On vehicles equipped with the 2.3L HSC/CFI engine, the steering wheel MUST be turned one-half a turn and released AFTER the ID code.
  3. If a Dynamic Response code occurs, briefly accelerate engine to wide open throttle (WOT). DO NOT depress throttle during test unless a Dynamic Response code occurs. The KEY ON/ENGINE RUNNING (KOER) SELF-TEST service codes will then be displayed. Observe and record all codes.
scientia non olet · About LEMON Manuals