LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1988 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Ignition System - DURA-Spark II >> Testing >> Control Module-To-Distributor Wiring Harness
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Module-To-Distributor Wiring Harness

  1. Separate 4-wire control module connector. Attach ohmmeter lead to distributor base. Alternately connect the other ohmmeter lead to wiring harness connector terminals that mate with Orange and Purple wires of control module connector.
  2. Resistance should be greater than 70,000 ohms. If within specification, proceed to IGNITION COIL SECONDARY RESISTANCE  test. If not, check wiring harness between control module connector and distributor. After test, reconnect 4-wire connector.
scientia non olet · About LEMON Manuals