LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1988 >> Bronco II 4WD, Standard, M5OD-R1 >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Ignition System - DURA-Spark II >> Testing >> Resistance Wire
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Resistance Wire

  1. Disconnect control module 2-wire connector and remove coil connector from coil. Connect ohmmeter leads to "BATT" terminal of coil connector and control module harness connector Red wire terminal.
  2. If resistance is .8-1.6 ohms, problem is either intermittent or not in ignition system. If resistance was below .8 ohms or more than 1.6 ohms, replace resistance wire. After test, reconnect all connectors.
scientia non olet · About LEMON Manuals