Single Switch

NOTE: See Fig 1 through Fig 3 for single switch pin locations.

With switch in released (neutral) position, continuity should exist between terminals No. 1 and 3, terminals No. 2 and 5, and terminals No. 4 and 6.
With toggle switch pushed downward, continuity should exist between terminals No. 2, 4 and 5, and terminals No. 1 and 3. Terminal No. 6 should be disconnected from any other terminal.
With toggle switch pushed upward, continuity should exist between terminals 2, 3 and 5, and terminals No. 4 and 6. Terminal No. 1 should be disconnected from any other terminal. If switch does not test as indicated, replace switch.

Fig 1: Single Switch Pin Locations (Bronco & "F" Series)

Courtesy of FORD MOTOR CO.

Fig 2: Single Switch Pin Locations (Aerostar, Bronco II, "E" Series & Ranger)

Courtesy of FORD MOTOR CO.

Fig 3: Single Switch Pin Locations (Bronco Tailgate)

Courtesy of FORD MOTOR CO.