Ignition Control Module: Service and Repair

Removal
1. Remove distributor, then 2 module attaching screws.
2. Pull right hand side of module down distributor mounting flange, then back up to disengage terminals from connector distributor base.
3. Pull toward flange and away from distributor to remove. Do not attempt to lift from mounting surface before moving entire TFI-IV module toward distributor flange, as connector pins will be damaged.

Installation
1. Apply a 1/32 inch coating of silicone grease to metal base of module. Position module on distributor mounting flange.
2. Carefully position module toward distributor bowl and securely engage the 3 distributor connector pins.
3. Install 2 module attaching screws and Torque to 15-35 inch lbs. Install distributor.