Test Fa: Step 3

3) Check Neutral Gear/Clutch Switch Input Circuit  Turn key off and wait 10 seconds. Install breakout box, leave ECA disconnected and set DVOM to 200-ohm scale. Measure resistance between test pins No. 30 and 46 with transmission in any gear and the clutch pedal in the UP position. If resistance is less than 5 ohms, on vehicles equipped with A/C, go to step 10). If not equipped with A/C, replace ECA and remove breakout box. Repeat QUICK TEST. If any reading is greater than 5 ohms, go to next step.