Test Fa: Step 5

5) Check Neutral Gear/Clutch Switch  Turn key off and wait 10 seconds. Leave breakout box installed and ECA disconnected. Set DVOM on 200-ohm scale. Locate Neutral Gear Switch (NGS) on transmission and Clutch Switch (CS) at clutch pedal linkage. Disconnect harness at both switches and inspect connector for pins that are pushed back. Measure resistance across NGS terminals with transmission in Neutral, and across CS terminals with clutch pedal depressed. If both resistances are less than 5 ohms, go to next step. If all resistances are more than 5 ohms, replace open switches as necessary, remove test equipment, reconnect components and repeat QUICK TEST.