Test Km: Step 2: Notes

2) Check Continuity of POWER-to-CLUTCH Circuit  Turn key off and wait 10 seconds. Set DVOM on 200-ohm scale. Disconnect A/C clutch harness and harness from WAC relay or A/C fan controller. Measure resistance between power side of A/C clutch vehicle harness connector and POWER-to-CLUTCH circuit terminal pin at WAC relay or A/C fan controller vehicle harness connector. If resistance is less than 5 ohms, reconnect A/C clutch and go to next step. If resistance is more than 5 ohms, service open circuit and retest system. System application is as follows: