Test N: Step 14

14) Check CID Circuit For Shorts  Turn key off, Install breakout box, leaving ECA disconnected. Disconnect DIS module. Set DVOM on 200-k/ohm scale. Measure resistance between Test Pin No. 24 and test pins No. 16, 37 and 40 at the breakout box. If all resistances are not greater than 10 k/ohms, repair CID circuit for short to GROUND or POWER. Remove breakout box, reconnect all components and rerun QUICK TEST. If all resistances are greater than 10 k/ohms, remove breakout box, reconnect all components and diagnose TFI or DIS system. See I - SYS/COMP TESTS article.