Pinpoint Test F - Brake Light On
- Ensure brake fluid level is okay. If brake fluid level is low, check for external leak and repair if necessary. If brake fluid level is okay, go to next step.
- Unplug connector from master cylinder reservoir cap. Check for continuity between pins No. 1 and No. 3. See Figure . If no continuity exists, go to step 3). If continuity exists, replace master cylinder reservoir cap.
- Check continuity between pin No. 2 of reservoir cap vehicle harness connector and ground. If continuity exists, repair circuit No. 977. If no continuity exists, verify BRAKE light is still on.