Cruise Control Switch: Service and Repair

1. Disarm airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2. Remove four air bag module retaining nuts.
3. Remove module from steering wheel, then disconnect contact assembly from module. Place air bag module on a flat surface, with the trim cover facing up.
4. Disconnect electrical connectors from switch.
5. Remove two screws and washers retaining switch to steering wheel.
6. Remove switch and wiring assembly.
7. Reverse procedure to install.
8. Reactivate airbag as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.