Test 29, Check VRS+ Shorted To VRS

With key off and ECA disconnected, disconnect VR sensor from vehicle harness connector. Set DVOM to 20-k/ohm scale. Measure resistance between breakout box pins No. J35 (VRS+ E) and J48 (VRS E).

If resistance is greater than 3 k/ohms, replace VR sensor. Remove all test equipment, and reconnect all components. Clear Continuous Memory, and check for fault codes. If resistance is less than 3 k/ohms, repair short circuit. Remove all test equipment, and reconnect all components. Clear Continuous Memory, and check for fault codes.