General Specifications

Connecting Rod Pin Bore Diameter 0.9432-0.9439
Connecting Rod Crankshaft Bearing Bore Diameter 2.2370-2.2378
Connecting Rod Crankshaft Bearing Bore Out-Of-Round 0.0004
Connecting Rod Crankshaft Bearing Bore Taper 0.0004
Connecting Rod Length (Center-To-Center) 5.1386-5.1413
Connecting Rod Alignment (Bore-To-Bore Max. Diff.), (Pin and crank bearing bore must be parallel and in same vertical plane within the specified total difference when measured at ends of an 8" bar, 4" on each side of rod centerline.)
Twist 0.006
Bend 0.002
Connecting Rod Side Clearance (Assembled To Crank)
Standard 0.0002-0.0025
Service Limit 0.014