LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1991 >> Probe GL, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Distributor >> Reassembly (Probe 2.2L Non-Turbo)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Reassembly (Probe 2.2L Non-Turbo)

  1. Install seal into distributor housing. Install retainer and bearing onto lower shaft. Install weights and springs onto lower shaft. Install new "E" clips. Install upper shaft onto lower shaft.
  2. Ensure weight pivot pins engage advance mechanism. Install upper and lower shaft assembly into distributor housing. Install stator plate into distributor housing. Install 2 retaining screws. Install vacuum diaphragm, "E" clip and 2 attaching screws.
  3. Install pick-up coil mounting plate and pick-up coil. Install pick-up wiring harness and wires. Using a socket and palm of hand, press signal rotor and pin onto upper shaft until it bottoms against shoulder of upper shaft.
  4. Note direction of arrow stamped into signal rotor. Install signal rotor retaining screw. Align groove in drive gear with alignment mark on distributor housing. Install retaining pin. Install cover, gasket and rotor.
scientia non olet · About LEMON Manuals