LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1991 >> Probe GL, Automatic >> Repair and Diagnosis >> Transmission >> Clutches >> Removal & Installation >> Clutch Assembly >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Clutch Assembly: Installation

  1. Clutch disc must be installed with flatter side toward flywheel as marked. Position clutch disc and align dowel pins of pressure plate onto flywheel. Start pressure plate bolts but do not tighten to flywheel. Install Clutch Plate Aligner (T81P-7550-A) into crankshaft pilot bearing.
  2. With clutch aligned, tighten pressure plate bolts in a crisscross sequence until they are just seated. Tighten cover bolts to specifications and remove clutch aligner.
  3. Before installation of transaxle, lubricate contact surfaces of transaxle input shaft, release bearing and release fork pivot point. Install new circlips on ends of half-shafts. To complete installation of transaxle, reverse removal procedure.
    AXLE SHAFT POSITIONING SPECIFICATIONS

    Application Length: In. (mm)
    2.2L TBI (Right & Left Side) 14.2 (360)
    2.2L Turbo (Right & Left Side) 13.9 (355)
    3.0L (Right & Left Side) 13.9 (355)
scientia non olet · About LEMON Manuals