Ca-3 Hydraulic Pump Motor Check From Abs Control Unit

Disconnect only Black wire from hydraulic unit. Start engine. Connect the following ABS control unit terminals to ground with jumper wire.

• Terminals 2K (Blue/Black wire) and 2I (Green/Red wire)
• Terminal 2I (Green/Red wire)
• Terminal 2K (Blue/Black wire)

Motor should operate only with 2I (Green/Red wire) jumpered to ground. If motor operates properly, repair Blue/Black and/or Green/Red wire(s) from ABS control unit to hydraulic unit. If motor does not operate properly, go to CA-4 ABS OUTPUT CHECK  .