Integrated Control Relay Module: Service and Repair

Fan, Motor and Integrated Relay Control Assembly

Integrated Relay Control Module:

Removal and Installation

1. Remove radiator sight shield.

2. Disconnect electrical connector. Remove integrated relay control assembly located on radiator support.

3. Disconnect electric fan connector.

4. Unbolt fan/shroud assembly from radiator.

5. Rotate fan/shroud assembly and remove past radiator.

6. Remove fan U-spring retainer from motor shaft and remove fan.

7. Unbolt fan motor from shroud.

8. To install, reverse Steps 1 through 7. Tighten fan retaining screws to 11-14 Nm (97-124 in.lb). Tighten shroud retaining bolts to 2.6-3.7 Nm (23-33 in.lb). Tighten shorud retaining nuts to 8-12 Nm (70-106 in.lb).