PW8: Check Power Window Signal
Turn the ignition key to the OFF position. Disconnect the power window main switch. Apply 12 volts to the wires marked (+) and ground the wires marked (-) shown below for 2 seconds, see WIRE VOLTAGE APPLICATION . Reverse the polarity for 2 seconds. Does the power window operate in both directions? If yes, replace the power window main switch. If no, go to the next step.
WIRE VOLTAGE APPLICATION
| Power Window | Main Switch Connector |
|---|---|
| Left Front | (-) Red/Black (+) Red/Green |
| Right Front | (-) Green/White (+) Red/White |
| Left Rear | (-) Green/Yellow (+) White/Red |
| Right Rear | (-) Blue/White (+) Yellow/White |