Output State Check

Output state check is used as an aid for servicing EEC-IV system output actuators. It allows technicians to operate most output actuators on command. This mode is entered from KOEO SELF-TEST after all codes have been retrieved. Leave SELF-TEST activated, and depress throttle to initiate test sequence. Each time throttle is depressed and released, output actuators will change from on to off or off to on.

Failure Mode Effects Management (FMEM), Code 98 Or 998 -FMEM mode allows system operation when sensors fail or transmit signals that are out of normal operating range. During FMEM mode, ECA substitutes a mid-range signal for defective sensor while continuing to monitor sensor. If faulty sensor's signals return to normal operating range, ECA will use those signals. A Code 98 or 998 will be displayed when FMEM mode is in effect.