SUPER STAR II Tester
1)
Turn engine off and allow it to cool. Turn all accessories off. Connect tester. See SUPER STAR II TESTER under QUICK TEST. Ensure tester center button is released.
2)
Place shift lever in Park (A/T) or Neutral (M/T). Turn tester on, and set center button to TEST position. Observe LED indication as each input device is tested. See SWITCH MONITOR TEST SPECIFICATIONS
.
3)
Test EEC input devices individually. Turn device off after test. Leaving device on while testing another device may produce false results and cause misdiagnosis. If input device fails test (reading on SUPER STAR II tester is not as indicated), perform related CIRCUIT TEST. See SWITCH MONITOR TEST SPECIFICATIONS
. If all input devices test okay and no code is stored in ECA memory, EEC system test is complete.
SWITCH MONITOR TEST SPECIFICATIONS
| Switch |
SUPER STAR II/VOM Indication |
Circuit Test |
| Clutch Engage/Neutral Gear Switch |
LED On/1.5 Volts; Transaxle In Gear & Clutch Pedal Released |
STG |
| Manual Lever Position Switch |
LED On/1.5 Volts; Transaxle In Park Or Neutral |
STP |
| Idle Switch |
LED On/1.5 Volts; Accelerator Pedal Depressed |
STG |
| Brake On-Off Switch |
LED On/1.5 Volts; Brake Pedal Partially Depressed |
STP |
| Headlight Switch |
LED On/1.5 Volts; Headlight Switch On |
STP |
| Blower Motor Switch |
LED On/1.5 Volts; Switch Set At 2 Or Higher |
STG |
| A/C Switch |
LED On/1.5 Volts; A/C & Blower Switch On |
STG |
| Defrost Switch |
LED On/1.5 Volts; Defrost Switch On |
STP |
| Coolant Temp. Sw. |
LED On/1.5 Volts; Cooling Fan On |
STP |
| Wide Open Throttle Switch |
LED On/1.5 Volts; Accelerator Pedal Fully Depressed |
STG |
| Knock Control |
LED On/1.5 Volts; While Tapping On Engine |
KC |
|
|
|
Courtesy of FORD MOTOR CO.
Courtesy of FORD MOTOR CO.