LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1992 >> Probe LX, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Fuel System >> INTERCOOLER Outlet Tube >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

INTERCOOLER Outlet Tube: Installation

  1. Install Teflon tape to circumference of sealing surfaces of outlet tube. Keep tape close to inner diameter, and overlap ends by 1/4". DO NOT stretch tape during installation, or a leak at sealing surface may develop.
  2. Install outlet tube underneath power steering pump bracket assembly. See Figure . Install power steering bracket and stud retaining nut. Tighten nut to specification. See TORQUE SPECIFICATIONS  at end of article.
    CAUTION: Carefully install outlet tube to avoid damaging sealing surfaces.
  3. Remove bolt installed in step 5) during removal. Install power steering pump bracket-to-cylinder head bolts, and tighten to specification.
  4. Install power steering pump bracket brace-to-water pump retaining studs. Tighten nuts to specification. Install outlet tube on lower stud on alternator/power steering pump bracket.
  5. Install push-on nut to hold outlet tube on pump bracket. Ensure outlet tube is free to move for alignment of sealing surfaces. Install outlet tube clamping connector over intake elbow assembly studs.
  6. Install and tighten nuts to specification. Ensure clamping connectors on outlet tube-to-intake elbow are parallel to intake elbow surface. Install nut on stud of alternator/power steering pump bracket and tighten nut to specification.
  7. Install outlet tube-to-cylinder block support bracket. Tighten bolt to specification. Tighten support bracket-to-front of cylinder block retaining nut and bolt to specification.
scientia non olet · About LEMON Manuals