Starter Motor: Service and Repair

When servicing starter or performing any maintenance in the area of starter, note heavy gauge input lead connected to starter solenoid is Hot at all times. Ensure protective cap is installed over terminal and is replaced after service.
1. Disconnect battery ground cable.
2. On models with automatic transaxle, remove kickdown cable routing bracket from engine block.
3. On all models, disconnect wire from starter solenoid ``S'' terminal. When disconnecting hard-shell connector at ``S'' terminal, grasp plastic shell and pull off. Do not pull on wire.
4. Remove starter solenoid attaching nut, then disconnect cable from terminal.
5. Remove starter mounting bolts, then the starter motor.
6. Reverse procedure to install. Torque starter mounting bolts to 15-20 ft. lbs.