LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1993 >> Explorer 2D Utility, RWD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 4.0L >> Summary
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Controls - Tests W/Codes - 4.0L: Summary

If no service code or Code 11 or 111 (pass code) is present, but drive-ability problem still exists, proceed to EEC-IV DIAGNOSIS BY SYMPTOM table. If driveability problem still cannot be located, go to TESTS W/O CODES article in the ENGINE PERFORMANCE Section for diagnosis by symptoms or intermittent diagnostic procedures.

EEC-IV DIAGNOSIS BY SYMPTOM

Symptom Application (1) Circuit Test
A/C Does Not Cut Off During WOT All Models KM - Step 15)
A/C Not Functioning All Models KM - Step 1)
Black Exhaust Smoke Except 7.3L H - Step 1)
CHECK ENGINE Light Always On Except 7.3L ML - Step 1)
CHECK ENGINE Light Flashing With Erratic Idle Except 7.3L ML - Step 15)
CHECK ENGINE Light Never On Except 7.3L ML - Step 4)
CHECK ENGINE Light On Intermittently Except 7.3L ML - Step 10)
Difficult Start Ranger 2.3L NB - Step 25)
Engine Hesitates After Hot Restart Except 7.3L H - Step 21)
Engine Hesitation Except 7.3L S - Step 2)
Engine Lacks Power or Loses Power Except 7.3L S - Step 2)
Engine Miss At Idle, Acceleration Or Cruise Except 7.3L S - Step 2)
Engine Runs Rough At All Times Except 7.3L S - Step 2)
Engine Stalls Except 7.3L S - Step 2)
Engine Stalls During Trans. Downshift Models With A/T TC - Step 1)
Engine Stalls During Trans. Engagement Models With A/T TC - Step 1)
Engine Stalls When Parking Models With PSP Switch FF - Step 2)
Engine Surge At Acceleration Or Cruise Except 7.3L S - Step 1)
Erratic RPM Except 7.3L S - Step 1)
Gasoline Fumes Modls With CANP KD - Step 1)
Late Shift Into 4x4 High Models With A/T TB - Step 5)
Overdrive Cancel Indicator Off Models With A/T TB - Step 4)
4x4 Low Light Always Off & Harsh Shift Models With A/T TB - Step 1)
4x4 Low Light Always On & Shift Slipping Models With A/T TB - Step 1)
(1) On models equipped with massairflow system, ensure air induction and electrical connections are clean and tight.