LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1993 >> Explorer 4D Utility, RWD, Automatic >> Repair and Diagnosis >> Body & Frame >> Power Windows >> Component Testing >> One-Touch Driver's Window(Explorer) >> Test Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test Procedure

  1. Use a 12-volt test lamp or Rotunda Digital Volt-Ohmmeter (007-00001) or equivalent to test the one-touch control module.
  2. With the ignition switch in the accessory position, connect a test lamp between terminal No. 5 (Black wire) and terminal No. 3 (Light Blue/Black wire). The lamp should light.
  3. With the test lamp connected to terminal No. 3 (Light Blue/Black wire), connect the other end of the test light to: Terminal No. 1 (Red Wire). The lamp should light. With test lamp connected to terminal No. 2 (White/Black or Red/Yellow wire), the lamp should light. With test lamp connected to terminal No. 4 (Yellow or Yellow/Red wire), the lamp should light. See WIRING DIAGRAMS  .
  4. Use a self-powered test lamp or ohmmeter to test the one-touch control module.
  5. With the one touch control module removed from the vehicle, check continuity between terminals No. 1 and 2. The lamp should light.
  6. Check continuity between terminals 1 and 3. The lamp should not light.
scientia non olet · About LEMON Manuals