KOEO Wiggle Test

Connect test equipment. See G - EEC-IV TESTS W/CODES article in the ENGINE PERFORMANCE Section. Turn ignition on. Activate self-test using jumper lead or diagnostic tester. Wait 10 seconds, and then deactivate and reactivate self-test to enter wiggle test. Tap, move and wiggle the suspected sensor and/or harness area. If a fault is detected, a code may be stored in memory and indicated at the diagnostic tester or scan tool. Record or retrieve code, and perform CIRCUIT TEST indicated in G - EEC-IV TESTS W/CODES article in the ENGINE PERFORMANCE Section.