Solenoid Valve (SV) Check At ABS Control Module
- Turn ignition off. Disconnect ABS control module. See Figure . Set VOM on 200-ohm scale.
- At ABS control module, measure and record resistance between following wires:
- Yellow /White wire and Yellow/Green wire (Left Front Solenoid).
- Yellow /White wire and Blue/Orange wire (Right Front Solenoid).
- Yellow /White wire and Brown wire (Left Rear Solenoid).
- Yellow /White wire and Black/Green wire (Right Rear Solenoid).
- If resistances are about 3 ohms, go to PINPOINT TESTS HSI-1 and HSI-2 . If resistances are not as specified, go to PINPOINT TEST SV-4 .