Ignition Systems
NOTE:
For additional information and descriptions, see IGNITION SYSTEMS in THEORY/OPERATION - GASOLINE
article in the ENGINE PERFORMANCE section. Perform spark output check in BASIC TESTING - GASOLINE
article in the ENGINE PERFORMANCE section before these tests. Some ignition systems require that QUICK TEST be performed before testing. This will retrieve trouble codes from EEC-IV system. Proceed to TESTS W/CODES - EEC-IV (GASOLINE)
article in the ENGINE PERFORMANCE section.
IGNITION SYSTEM ACRONYMS (1)
| Acronym | Definition | ||
|---|---|---|---|
| BAT+ Or BAT (+) | Battery Positive | ||
| BAT- Or BAT (-) | Battery Negative | ||
| BOB | Breakout Box | ||
| CCD | Computer Controlled Dwell | ||
| CID | Cylinder Identification | ||
| C1, C2, C3 | Coil Drive (Coils 1, 2 & 3) | ||
| DI | Distributor Ignition System | ||
| EI | Electronic Ignition System (Distributorless) | ||
| DPI | Dual Plug Inhibit (High Signal, Right Plugs Fire; Low Signal, Both Sides Fire) | ||
| ICM | Ignition Control Module | ||
| IDM | Ignition Diagnostic Monitor (Diagnostic Signal To PCM) | ||
| IGGND | Ignition Ground (Low Current Ground Reference) | ||
| KOEC | Key On Engine Cranking (Testing Condition) | ||
| KOEO | Key On Engine Off (Testing Condition) | ||
| KOER | Key On Engine Running (Testing Condition) | ||
| PCM | Powertrain Control Module | ||
| PIP | Profile Ignition Pickup (Crankshaft Sensor Signal) | ||
| PWR GND | Power Ground Circuit | ||
| SPOUT | Spark Output (PCM Spark Control Signal) | ||
| VPWR Or VBAT | Battery Power Or Battery Voltage | ||
|
|||
IGNITION SYSTEM IDENTIFICATION
| Application | System |
|---|---|
| 4.9L | DI (Push Start) |
| 5.0L | DI (CCD) |
| 5.8L & 7.5L | DI (Push Start) |