Test C - Right Window Inoperative
- Perform MAIN SWITCH TEST under TESTING. If main switch is okay, go to next step. If main switch fails test, replace main switch.
- Perform MOTOR TEST under TESTING. If window motor is okay, go to next step. If motor fails test, replace motor.
- With ignition off, disconnect right switch connector. Turn key to ON position. Measure voltage of Black/Red wire at connector. If voltage is greater than 10 volts, go to next step. If voltage is less than 10 volts, repair Black/Red wire.
- Perform RIGHT CONTROL SWITCH TEST under TESTING. If right control switch fails test, replace switch. If switch is okay, go to next step.
- With ignition off, disconnect both main control switch and right control switch connectors. Measure resistance of Green/White and Red/White wires between main switch and right switch connectors. Measure resistance of Green/White and Red/White wires between main switch and ground. Resistance between switches be less than 5 ohms. Resistance between switch and ground should be more than 10,000 ohms. If resistances are correct, repair wire(s) between right control switch and right window motor. If resistances are not correct, repair wire(s) in question.