Power Seat Switch (6-Way)
- Using a voltmeter, check for battery voltage in feed wire from main fuse panel. Check ground connection.
- Disconnect power seat motor connector. Ensure power seat switch is connected. Using a voltmeter, measure voltage at connectors and under conditions listed. See POWER SEAT SWITCH TEST SPECIFICATIONS table. See Fig 1 . If voltages are not as specified, replace power seat switch.
POWER SEAT SWITCH TEST SPECIFICATIONS
| Connector & Wire Color | Switch Position | Volts | |
|---|---|---|---|
| Lift Motor | |||
| Yellow/Red | Up | Greater Than 10 | |
| Yellow | Up | Less Than 1 | |
| Yellow/Red | Down | Less Than 1 | |
| Yellow | Down | Greater Than 10 | |
| Slide Motor | |||
| Green | Forward | Greater Than 10 | |
| Green/White | Forward | Less Than 1 | |
| Green | Backward | Less Than 1 | |
| Green/White | Backward | Greater Than 10 | |
| Tilt Motor | |||
| Red | Up | Less Than 1 | |
| Red/White | Up | Greater Than 10 | |
| Red | Down | Greater Than 10 | |
| Red/White | Down | Less Than 1 | |