LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1995 >> Crown Victoria Base >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System >> Testing >> Hydraulic System Pressure & Flow Test >> Minimum Flow Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Minimum Flow Test

  1. Connect Power Steering System Analyzer (014-00207) between pressure line and pump, with gauge between pump and tester valve. Add power steering fluid if needed. Start engine and allow to idle for approximately 2 minutes with idle set to specification. Record flow, gallons/minute (liters/minute).
  2. If flow is less than 1.5 gallons/minute (5.7 liters/minute), power steering pump may require service, but continue diagnosis. If pressure is above 150 psi (10.5 kg/cm2 ) at idle, check hoses for restrictions.
  3. Partially close gate valve on tester to build up pressure to 740 psi (52.0 kg/cm2 ). Observe and record flow. If flow is below minimum specification, service power steering pump. See POWER STEERING PUMP FLOW TEST SPECIFICATIONS  . Proceed to RELIEF PRESSURE TEST  .
scientia non olet · About LEMON Manuals