Pinpoint Test C - Right Power Window Inoperative

Power Window Master Switch Check: Perform master switch test. See MASTER SWITCH under COMPONENT TESTING. If master switch is good, go to next step. If master switch is faulty, replace switch and retest system.
Passenger's (Single) Power Window Switch Check: Perform single switch test. See SINGLE SWITCH under COMPONENT TESTING. If the single power window switch is good, go to next step. If the single power window switch is faulty, replace switch and retest system.
Power Window Motor Check: Perform power window motor test. See POWER WINDOW MOTOR under COMPONENT TESTING. If motor is good, go to next step. If motor is faulty, replace motor and retest system.

Power Window Switch Circuit Check: Turn ignition off. Access and unplug the Master power window switch connector, passenger's (single) power window switch connector and the power window motor connector. Measure resistance in the appropriate wires of passenger's power window circuits. Refer to the RIGHT SIDE POWER WINDOW CIRCUIT IDENTIFICATION table. Also, refer to Fig. Figure . If all resistances are 5 ohms or less, go to next step. If any resistance is greater than 5 ohms, repair open in wire(s) in question. Retest system.

RIGHT SIDE POWER WINDOW CIRCUIT IDENTIFICATION

Circuit Function		Wire Color
Front Window
Lockout Switch Output		Black/Blue
Switch Downward		Dark Green/Yellow
Switch Upward		White/Red
Rear Window
Switch Downward		Dark Blue/White
Switch Upward		Yellow/White

Power Window Motor Circuit Test: Turn ignition off. Unplug the right rear power window switch and the right rear power window motor connectors. Measure resistances of the Red and Green wires between the switch and motor connectors. See Figure . If resistances are less than 5 ohms, replace power window motor. If any circuit resistance is greater 5 ohms, repair open in wire(s) in question. Retest system.