Blower Motor Speed Control

A/C Blower Motor Speed Control

Removal

1. Disengage glove compartment door stops and allow door to hang by hinge.

2. work:ng through glove compartment opening, disconnect electrical snap-lock connector and aspirator hose at A/C blower motor speed control.

3. Disconnect snap-lock connector from its mounting bracket.

4. Remove two screws retaining A/C blower motor speed control to A/C evaporator housing and remove A/C blower motor speed control. Do not touch fins of controller until it has had sufficient time to cool.

Installation

1. Position A/C blower motor speed control on A/C evaporator housing and install two retaining screws.

2. Connect wire connector and aspirator hose to A/C blower motor speed control. Install connector on mounting bracket.

3. Close glove compartment door.

4. Check system for proper operation.