LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1995 >> Explorer 4D Utility, RWD, Standard >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System >> Overhaul >> Control Valve Housing >> Reassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Valve Housing: Reassembly

  1. If inlet tube seats were removed, coat new seats with petroleum jelly and install using Tube Seat Installer (T74P-3504-M). Coat bearing and seal surface of housing with petroleum jelly.
  2. Using Installer (T65P-3524-A1), press pre-lubricated bearing into housing with metal covering facing out. Bearing should rotate freely after installation. If bearing does not rotate freely, too much pressure was used to install. Replace bearing.
  3. Coat new housing oil seal with power steering fluid. Position seal into housing with metal side out. Using Installer (T65P-3524-A1), drive seal into housing but DO NOT  fully seat seal yet. Remove installer, squeeze snap ring and place on top of seal. Finish driving snap ring and seal inward until snap ring seats in groove.
  4. Place new dust seal in housing with dished rubber side out. Using Installer (T65P-3524-A1), press inward until seal is located just behind undercut on input shaft. Apply generous amount of multipurpose grease to area between seal lips.
scientia non olet · About LEMON Manuals