Pinpoint Test C - One Touch Down Feature Inoperative

Power Supply To One Touch Module Check - Remove driver's door trim panel. Access module located in driver's door. Turn ignition to ON or ACCESSORY position. Check Purple wire for voltage at module connector. If battery voltage does not exist, go to next step. If battery voltage exists, go to step 3).
One Touch Circuit Ground Check - Check resistance between Black wire at one touch module and ground. If resistance is 5 ohms or less, go to next step. If resistance is greater than 5 ohms, repair open in black wire. Retest system.
One Touch Down Switch Sense Test - Actuate driver's window switch for downward operation. Hold the button down. If driver's window does not move down, refer to PINPOINT TEST B . If driver's window moves down, replace one touch down module. Retest system.