NA8 - Check ICM Module

- Key "OFF".

- Breakout box installed.

- Connect Powertrain Control Module (PCM) to breakout box.

- Reconnect ignition coil and Ignition Control Module (ICM).

- Connect Digital Volt/Ohm Meter (DVOM) between test pin 4 and test pin 16 at the breakout box.

- Start engine.

- Observe DVOM when voltage is allowed to stabilize.

- Lightly tap on ICM to simulate road shock.

- Wiggle ICM connector and Camshaft Position (CMP) sensor connectors.

- A sudden change in voltage indicates a fault.

- Is a fault indicated?

Yes -- Disconnect and Inspect connectors. If connector and terminals are good, remove breakout box, reconnect all components and Refer to Ignition Systems for Distributor Ignition (DI) Diagnostics.

No -- Go to NA9. NA9 - Check EEC Harness