With Generic Scan Tool

These are general instructions for operating a generic scan tool. Refer to the manufacturer's manual for specific instructions.

- Perform the necessary vehicle preparation and visual inspection.

- Connect scan tool to DLC.

- Turn ignition key to the On position or START vehicle (depending on the pinpoint/diagnostic instructions for the data requested).

- Verify tool is connected and communicating properly (if necessary, enter the OBD II System Readiness Test to verify communication). On-Board System Readiness Test Access

- Go to the scan tool PID screen to access PIDs (no extended data entry should be required).

- View the requested information.

- When finished, turn ignition key to the Off position.

- Disconnect scan tool from vehicle.