LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1997 >> Contour Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Module Communications Network) >> Communication Network Diagnostics >> On-Demand Self-Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Demand Self-Test

WARNING: This page is about a different car, the 1997 Ford RV Cutaway, 1997 Ford Econoline, 1997 Ford Cutaway, and 1997 Ford Club Wagon. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: On-Demand Self-Test may be used to verify operation of a selected module.
  1. Connect New Generation Star (NGS) scan tester on Data Link Connector (DLC) and perform proper hook-up procedure. See EQUIPMENT HOOK-UP .
    NOTE: If instructed to perform On-Demand Self-Test from a specified test procedure, ensure ignition is in proper position as listed in test procedure or the test will fail.
  2. Turn ignition switch to RUN position unless otherwise instructed by specified test procedure. Rotate dial on scan tester to DIAGNOSTIC DATA LINK menu and press trigger.
  3. Rotate dial on scan tester to highlight the desired module to be tested and press trigger. Ensure DIAGNOSTIC TEST MODES is highlighted and press trigger.
  4. Rotate dial on scan tester to highlight ON-DEMAND SELF-TEST and press trigger. Press button No. 3 to start the test. Prepare vehicle for entry condition as specified for each module. Press trigger. Record any Diagnostic Trouble Codes (DTCs) that are displayed.
scientia non olet · About LEMON Manuals