Power Window Master Switch
WARNING: This page is about a different car, the 1997 Ford Ranger and 1997 Ford Aerostar. However, it is still accessible from the selected car via links, so may be relevant.
Remove master switch from vehicle. See POWER WINDOW SWITCH under REMOVAL & INSTALLATION. Measure resistance between specified terminals while operating switch. See appropriate MASTER SWITCH TESTING TABLE. See Fig 1 or Fig 2 . Replace switch if resistance between specified terminals is greater than 5 ohms. DO NOT check resistance between terminals not specified.
MASTER SWITCH TESTING
| Switch Position | Continuity Between Terminals No. | |
|---|---|---|
| Neutral | 1, 2, 3, 4 & 5 | |
| Left | ||
| Up | 2 & 6; 1 & 5 | |
| Down | 1 & 6; 2 & 5 | |
| Right | ||
| Up | 4 & 6; 3 & 5 | |
| Down | 3 & 6; 4 & 5 | |
MASTER SWITCH TESTING
| Switch Position | Continuity Between Terminals No. | |
|---|---|---|
| Neutral | 1, 3, 4, 6 & 2 | |
| Left | ||
| Up | 1 & 5; 2 & 4 | |
| Down | 4 & 5; 1 & 2 | |
| Right | ||
| Up | 5 & 6; 2 & 3 | |
| Down | 3 & 5; 2 & 6 | |