Power Window Single Switch
WARNING: This page is about a different car, the 1997 Ford Ranger and 1997 Ford Aerostar. However, it is still accessible from the selected car via links, so may be relevant.
Remove single switch from vehicle. See POWER WINDOW SWITCH under REMOVAL & INSTALLATION. Measure resistance between specified terminals while operating switch. See appropriate SINGLE SWITCH TESTING TABLE. See Fig 1 or Fig 2 . Replace switch if resistance between specified terminals is greater than 5 ohms. DO NOT check resistance between terminals not specified.
SINGLE SWITCH TESTING
| Switch Position | Continuity Between Terminals No. |
|---|---|
| Neutral | 1 & 3; 4 & 6 |
| Up | 2 & 3; 4 & 6 |
| Down | 2 & 4; 1 & 3 |
SINGLE SWITCH TESTING
| Switch Position | Continuity Between Terminals No. |
|---|---|
| Neutral | 1 & 2; 4 & 5 |
| Up | 1 & 3; 4 & 5 |
| Down | 3 & 5; 1 & 2 |