LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 1997 >> Crown Victoria Base, 4.6 9 >> Repair and Diagnosis >> Body & Frame >> Body, Cab Control Systems >> Module Communications Network System >> Testing >> Test H: Driver Door Module Does Not Respond
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test H: Driver Door Module Does Not Respond

  1. Disconnect Black 16-pin harness connector C211 (located behind left side kick panel). Measure resistance by backprobing between driver's door module 12-pin connector C518 (located in driver's door) pin No. 1 (Light Blue/White wire) and female side of 16-pin harness connector C211 terminal No. 4. See Figure. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open in Light Blue/White wire. Reconnect connectors. Repeat DATA LINK DIAGNOSTICS  under COMMUNICATION NETWORK DIAGNOSTICS.
  2. Disconnect driver's door module 12-pin connector C518. Inspect driver's door module 12-pin connector C518 pin No. 1 (Light Blue/White wire) and wire connection. If pin and wire connection is okay, go to next step. If pin and/or wire connection is damaged, repair as necessary. Reconnect connectors. Repeat DATA LINK DIAGNOSTICS under COMMUNICATION NETWORK DIAGNOSTICS .
  3. Inspect driver's door module pins. If pins are okay, replace driver's door module. If pin(s) are damaged, repair as necessary. Reconnect connectors. Repeat DATA LINK DIAGNOSTICS  under COMMUNICATION NETWORK DIAGNOSTICS.
scientia non olet · About LEMON Manuals