Lock Cylinder (Non-Functional): Installation
- Install lock cylinder gear, washer and retainer into lock cylinder bore in column housing. Ensure ignition switch is in RUN position by rotating lock cylinder gear fully clockwise to START position, then releasing. Ensure lock cylinder gear keyway is correctly aligned with slot in ignition switch shaft.
- Turn NEW lock cylinder to RUN position. Press lock cylinder retaining pin located on bottom of lock cylinder. Install lock cylinder. Ensure lock cylinder is fully seated and aligned in interlocking washer.
- Turn lock cylinder to OFF position to release retaining pin into hole in column housing. Connect electrical connectors to key warning switch and ignition switch. Install upper and lower column shrouds. Install steering wheel. Connect battery cables. Ensure vehicle starts in Park and Neutral positions (A/T), vehicle does not start in Drive or Reverse position (A/T), and column locks with ignition switch in LOCK position. Check AIR BAG light for system faults.